Reusable hose fitting standard presentation .

Which is larger than the hole size should be appropriate to the size of the enhancement layer, or can not load, or even cause an enhancement layer completely loose head phenomenon. Clearance is generally 1 ~ 1.5mm. Coat the inside of the groove will directly affect hydraulic hose adapters the quality of the joint. There are currently no slot straight holes, jagged and serrated groove and an annular trough combined. Cotton (fiber) due to the use of low pressure braided hose, pull off force is small, have adopted no-slot structure. Wire braided hose in the enhancement layer prone to withhold its bending, multi-use serrated. Steel Pipe layers generally more unilateral enhancement layer thickness up to 3.6mm, while withholding make enhancement layer wavy deformation into the trench must adopt zigzag ring and groove combination, this slot sawtooth-shaped than the width of 2/3, its anti-pull off stronger.hydraulic adapters Withholding process is the most important factor affecting quality. Impact withhold hose connector assembly quality is the most important process factors withhold processes. There are currently two ways to withhold An axial push-in (Fig. 4) can be used in common for mold press to be achieved. Its not easy to adjust the amount withheld, the withholding process is easy to damage the outer surface of the jacket. To remove withhold pieces. The mold must be made waffle. It has a seam that finished look bad. Another radial withhold its mold has folio, three, six and eight-mode points. Six lobe is generally used for mass production, and eight petal mold to ensure the quality of basic withhold the correct amount of compression to master the rubber hose and coats withholding amount. According to production practice. Empirical formula can be used to calculate the amount of compression is relatively simple glue.