cutting machine features and considerations

Feature
1 sawblade. Low noise. Safety;

2 foot switch, automatic pressure and cutting operations;

3 Use the 12mm rubber block binder, not damaged;

4 can be single or multiple sections with saws;

5.800mm long feed channel plate can improve sawing accuracy;

6 automatic side injection, oil can be adjusted separately. Cut no edges, the blade is more durable;

7 This machine was valve block computer machining, sawing accuracy.

Edit this paragraph
Precautions

1) Move the table or spindle, according to the near or far with the workpiece correctly selected speed, moving too fast to prevent a collision.

2) When programming according to the actual situation to determine the proper processing and processing route, to eliminate the position due to inadequate processing or take the side of the workpiece caused by insufficient strength scrapped

Or early fall off.

3) wire cutting programs and must be confirmed before the amount of compensation is correct.

4) Check the wire tension is adequate. In cutting taper, the tension should be adjusted down to the usual half.

5) Check the electrode wire feeding speed is appropriate.

6) to be processed according to the actual situation of open selection process or adhesion process, under the premise of avoiding interference to shorten the distance between the nozzle and the workpiece. Adhesion plus

Hours of work, the distance between the nozzle and the workpiece generally take 0.05 ~ 0.1mm.

7) Check the jet hydraulic couplings stream selection is reasonable, high pressure jet roughing, finishing with a low pressure jet.

8) from the cutting process stability should observe judge found that adverse timely adjustments.

9) process, should regularly inspect and supervise the cutting conditions and found the problem immediately.